How do I put the filter in my Intex pool

Tips for Installing a Sand Pool Filter Before running for the first time, backwash the filter with the pool pump off. Ensure the wastewater line is ready and releases water in your chosen location. After backwashing the filter, turn the pool pump on and set the sand filter to the filter setting.

Does pool filter go before or after pump?

Tips for Installing a Sand Pool Filter Before running for the first time, backwash the filter with the pool pump off. Ensure the wastewater line is ready and releases water in your chosen location. After backwashing the filter, turn the pool pump on and set the sand filter to the filter setting.

How does a cartridge pool filter work?

A cartridge filter uses cloth-type material as the filtering agent. Water is introduced through the filter, runs through the material, and sends clear water back into the pool. The cartridges, themselves, usually need to be replaced every 3 to 4 years, depending on usage.

Where do you put a water filter?

The water filtration system should be installed in-line with the existing plumbing line. Look for a horizontal run after the home’s main shut-off valve, before it branches off to other parts of the house.

Can I use an extension cord with an above ground pool pump?

It’s highly recommended never to use an extension cord to power a pump of an above ground swimming pool. … A pool pump requires a great deal of power and that you can’t provide with a normal extension cord. You’d need one with a #12-gauge wire or a #10-gauge wire.

Do I need a pump for my Intex pool?

Intex pools — the same as with all other swimming pools — require a filter, pump and the appropriate chemicals, such as chlorine, to keep the pool water clean and sanitary for swimmers.

How do I start my pool pump?

Turn off the pump. …
Switch to recirculate. …
Release air. …
Clean out the pump basket. …
Fill the pump basket. …
Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
Check the water flow to your pump.

How long should I run my Intex pool pump?

Run your filter pump for at least 12 hours a day, every day. This will make sure all the water in your pool circulates at least once. In an ideal world of bottomless money vaults, you could run your pool pump 24 hours a day, but 12 hours is a good compromise.

How does the Intex pool pump work?

To keep the Intex pool clean, it’s important to use an Intex pump, which is a small pump located on the outside of the pool that works by cycling the water through a connected filter and back into the pool.

Do you still use chlorine with a sand filter?

Sand filters use chlorine because the sand is added for filtration, but chlorine sanitizes the swimming pool water. Sand, cartridges, and DE can’t replace chlorine because they have different purposes. However, you can use swimming pool robots, salt systems, and other tools to improve your pool water.

Article first time published on

Where do you put the pool equipment pad?

Location of pool pad: The best location is a compromise between the distance from the main house electrical box and gas meter, if you are planning on a gas heater. It should be close to the level of the pool water and easily accessible. If you put it too far away, it will be inconvenient to check on regularly.

How far should the filter be from the pool?

Stay close to the pool Our projects typically average a distance of 20–40 feet from the pool to the equipment, but as stated earlier, much longer runs are sometimes required.

How far does pool equipment have to be from house?

Every pool shall be equipped with an approved filter unit and drain. The location of pool equipment shall require an additional inspection and approval by the Noise Enforcement Inspector, when the pool equipment is located less than 10 feet from a property line of an adjoining property.