How do you remove the blades from a Cub Cadet riding lawn mower

Are Cub Cadet Lawn Mower Blades Reverse Thread According to Club Cadet, the retainer nut on most blades “…is a standard right-handed thread (rotate clockwise to tighten, counterclockwise loosen) and should be tightened to between 70 and 90 foot-pounds of torque to fasten securely.”

Are Cub Cadet mower blades reverse threaded?

Is the bolt on a lawn mower blade reverse threaded?

Generally speaking, most lawnmower blade nuts are reversely threaded to firmly secure the blade onto the drive shaft of the engine. To remove the blade on this type of mower, the blade’s retaining bolt should be turned to the left or counterclockwise direction. …

Which way do you turn the bolt to remove a riding lawn mower blade?

To remove the blade, you must turn the blade’s retaining bolt to the left, or counterclockwise. Before undoing the blade, tip the mower on its side with the engine air cleaner facing up and block the blade with a piece of wood so it can’t turn.

How do you loosen a nut on a lawn mower blade?

Put a wrench socket of the correct size on the head of the bolt securing the blade to the blade holder, and apply force to the wrench handle in the counterclockwise direction to loosen the blade bolt. The bolt may have a 1/2-inch, 5/8-inch or 3/4-inch head, depending on mower model.

Which side of the lawn mower blade is up?

The wings of the lawn mower blade will be oriented up toward the mower deck and any writing on the blade will likely be facing away from the deck. If the blade bolt comes with a washer, its concave side will be facing the blade.

Are mower blade bolts left hand thread?

The overwhelming majority of mower blade retainers (almost all are bolts) are normal right hand thread. The best indicator that the method of retaining the blade(s) might deviate from the norm would be found in the side which the grass is discharged from the mower deck.

What happens if mower blade is upside down?

Mower blades have a cutting edge at each end. … It is common to install a blade upside down. When this happens, the lawn mower will not cut correctly, or it could damage the mower.

What size nut is on a Cub Cadet mower blade?

The retainer nut on most of our riding mower blades are a 5/8″ thread diameter. This sized thread diameter nut normally requires a 15/16″ wrench or socket tool in order to remove/install.

Where do you jack up a Cub Cadet?

Place the jack under the front cast iron axle or under the rear axle housing nearest the wheel that is to be removed. DO NOT place jack or block the tractor at the center point of the front or rear axles, as the tractor may become unstable on the jack stand or block once the wheel to be repaired is removed.

Article first time published on

How do you lift the back of a zero turn mower?

Park the zero-turn lawn mower on a hard, level surface and set the parking brake. …
Raise the mower deck to the highest position by pulling all the way back on the mower deck lift lever. …
Raise the jack until the front of the machine is approximately 2 feet off the ground.

What size socket do I need to take off a lawn mower blade?

Dismount the mower deck from the lawn tractor to replace worn-out mower blades. Changing the mower deck’s three blades requires a 1 1/8-inch socket, box or open-end wrench for hex nuts, a block of wood and a set of new blades.