The (clear) main fuel line with the filter (filter inside the fuel tank) goes to the bottom of the carburetor (or the elbow shaped nipple). The (clear) fuel intake line runs from the top of the carburetor (straight nipple) and goes to the short post on the back of the primer bulb.
What size fuel line does a Poulan chainsaw use?
Fuel Line Specifications. This is the replacement fuel line 25 Inch for several OPE products that use small engines. The fuel line carries fuel from the tank to the carburetor.
How do you change a primer bulb on a Poulan chainsaw?
- Let’s get started. …
- Remove the top cover.
- Remove the starter assembly.
- Remove the air filter housing.
- Remove the carburetor.
- Remove the purge bulb.
- INSTALLING THE NEW PRIMER BULB [top] 7. …
- Install the purge bulb.
How do you install a fuel line on a chainsaw?
- Drain the fuel tank. Wear work gloves to protect your hands. …
- Remove the cylinder shield. …
- Disconnect the spark plug wire and remove the air filter. …
- Remove the fuel filter. …
- Remove the carburetor. …
- Remove the old fuel lines. …
- Install the new fuel lines. …
- Install the fuel filter.
What connects to a carburetor?
The carburetor uses fuel from the fuel tank to supply gasoline to the engine. There is typically a hose or metal tube for this, called the fuel supply line, that connects to the carburetor.
Does 40 to 1 have more oil than 50 to 1?
A 40:1 oil mix ratio means 40 units of gas for a single unit of oil drop. Likewise, in a 50:1 gasoline, there are 50 units of gas. So, a 40:1 oil mix is denser and lubricates better than 50:1.
How can you tell if the fuel filter is bad?
Use a large straw or a small hose and apply it to one end of the fuel filter. Blow into the straw or hose. If your breath goes through with little resistance, your fuel filter is still in good condition. If you have a hard time blowing air through the fuel filter, then it is clogged and must be replaced.
What kind of oil does a Poulan Pro use?
Poulan Pro uses Briggs and Stratton engines in its products. On its website, Briggs and Stratton recommends using a high-quality detergent oil based on the temperatures in your climate. Engine oil products labeled as “SAE 30″ work in temperatures above 40 degrees Fahrenheit but are not meant for cold conditions.
