How much does it cost to replace a starter in a Chevy Silverado

Chevrolet Silverado 1500 Starter Replacement Cost Estimate. Labor costs are estimated between $128 and $162 while parts are priced between $250 and $357. This range is based on the number and age of Chevrolet Silverado 1500’s on the road.

Where is the starter on a Chevy Silverado?

The location of the starter on the 2015 Chevrolet Silverado 1500 is underneath the truck, on the passenger side and behind the down pipe. The starter uses the engine’s battery to turn the flywheel and kick the engine to life, without it the truck would not be able to start.

Can you change a starter yourself?

You can buy a new starter, which is rather expensive, or you can buy a rebuilt starter, which is just as good as a new one [source: Allen]. If the problem is really your starter, save yourself a trip to the mechanic and replace it yourself. … Disconnect all the bolts that hold the starter to the block, using a ratchet.

Where is the starter located?

Listen for a clicking sound coming from under the hood and look for a cylindrical part bolted near the engine. There are usually two hex bolts securing the starter, though there can be more. If you can find this part without too much hunting around, it is the starter.

What are signs of a bad starter?

Something sounds off. …
You’ve got lights but no action. …
Your engine won’t crank. …
Smoke is coming from your car. …
Oil has soaked the starter. …
Look under the hood. …
Tap the starter. …
Adjust the transmission.

What would cause a Chevy truck not to start?

The most common reasons a Chevrolet Silverado 1500 won’t start are a dead battery, an alternator problem, or failed starter.

What is the cost of replacing a starter?

How Much a Starter Replacement Costs. The cost of rebuild parts for a starter can range from as little as $50 to as much as $350. A brand-new starter can range from $80 to over $350. For a qualified mechanic to replace or rebuild your starter, you can expect to pay between $150 and over $1,100.

Can you jump a car with a bad starter?

Jump-starting a car with a bad starter motor will not help start the engine. Jump-starting will only boost battery power. A manual transmission car with a bad starter maybe push or tow started but an auto transmission car can not.

How long does a starter last?

On average, a starter motor lasts for 100,000-150,000 miles. In many cars, the starter motor lasts for the lifetime of the vehicle; however in some cars, it can fail prematurely.

What causes a starter to go bad?

CAUSES OF FAULTY STARTERS: CAUSE OF FAILURE Electrical connections faulty. Solenoid switch (engaging relay) stiff or faulty. Electric motor damaged electrically. Single-pinion gear, starter pinion or freewheel damaged.

Article first time published on

What is the first step to follow when removing a starter?

Safety First. Disconnect the battery. …
Remove the Wiring. Remove the wiring and positive battery cable from the starter solenoid.
Remove the Starter and Bolts. Remove the starter retaining bolts. …
Compare to Verify. …
Transfer Heat Shield. …
Replace with New Starter. …
Secure and Tighten. …
Connect the Wiring.

Is it hard to change a starter?

Replacing a car’s starter motor isn’t difficult. However, vehicles with large engines will be more challenging. … In this post, you’ll learn how difficult it is to replace a starter motor on both front-wheel drive and rear-drive cars.

How long does it take to change a starter?

How long does it take to replace a starter motor? Depending on the type of vehicle, typically a starter motor replacement will take a mechanic between 2 and 4 hours to complete from start to finish.

How do you tell if it's your starter or ignition switch?

Test the Starter It is under the hood, usually on the passenger side at the bottom of the motor next to the transmission. The ignition switch is a set of electrical contacts that activates the starter and usually is located on the steering column.

Where is the starter located on a 2010 Chevy Silverado?

The starter in Your 2010 Chevy Silverado is mounted to the lower engine block on the passenger side of the truck. You can access it through the passenger wheel well or from underneath the vehicle. You will need an 8mm, 13mm and a 14mm socket to remove the starter.

Is it worth rebuilding a starter?

New: A new starter or alternator provides you with a working system where all parts are at the same stage of wear and tear, but it’s often the most expensive option. … A rebuilt system won’t have all its parts at the same state of wear and tear, but it’s an affordable alternative to buying a new alternator or starter.

What does it mean when car won't start but clicks?

A rapid clicking noise when trying to start your car could mean there’s something wrong within the electrical system. Perhaps your battery’s dead, or your alternator, which charges the battery, isn’t working correctly. … You may need to replace your alternator or battery.

How do you tell if its your starter or your battery?

Last, Check The Starter The battery sends a burst of energy to the start which uses this energy to turn the engine over and get it car started. If you put the key in the ignition, but only hear a click when you turn the key, you’ve got a problem with your starter.

Why does tapping on a starter make it work?

It works because the brushes in the starter are worn to the point where they are having trouble contacting the commutator bars of the armature. Works best when power is being applied. All that said, fair warning: hitting it too hard can damage the perminant magnets in the motor.

How do you start an automatic car with a bad starter?

Jump-Start Your Car. …
Push-Start Your Engine. …
Check The Connections. …
Check The Engine Grounds. …
Examine The Starter Solenoid Cable. …
Examine The Engine Flywheel. …
Inspect For Corrosion. …
Tap The Starter.

How do I test my starter with jumper cables?

With the ignition turned off and the transmission in “park” — and with all due care — connect one end of the red/positive jumper cable to the positive terminal of the battery. Touch the other end of the red cable to the positive terminal on the starter motor. The starter should spin/crank the engine.

Can a bad starter cause a crank no start?

Starter Troubles A starter that’s failing may crank the engine too slowly for a quick start, or it may not crank the engine at all. Often, the problem is not the starter but a low battery or a loose or corroded battery cable connection.

What causes no crank no start?

If an engine cranks but refuses to start, it lacks ignition, fuel or compression. Was it running fine but quit suddenly? The most likely causes here would be a failed fuel pump, ignition module or broken overhead cam timing belt.

Can you tap a starter to make it work?

The starter cannot function properly if that happens. Give the starter a tap about 4 to 5 times with a tool such as a hammer or a wrench. … Sometimes, this method works even if the starter is actually bad. In that case, tapping will provide a temporary fix but the car could be dying anytime soon.