ManufacturerTransmission TypeTransmission FluidCHEVROLET4L60EDEXRON IIIISUZU4L60EDEXRON IIIOLDSMOBILE4L60EDEXRON IIIPONTIAC4L60EDEXRON III
What type of transmission fluid does GM take?
DEXRON-VI Automatic Transmission Fluid is suitable for use in vehicles that specify the following requirements: fully licensed and approved by GM, recommended for use in GM transmissions model year 2006 and newer calling for DEXRON-VI Automatic Transmission Fluid (replaces DEXRON-III and DEXRON-II(E), or recommended …
Is ATF and ATF 4 transmission fluid the same?
ATF +4 is a synthetic fluid for finely-tuned transmissions, so if you use a non-synthetic ATF instead of ATF +4 in a car or truck that calls for it, you could damage the transmission. You may use ATF +4 in most applications that call for older Dexron and Mercon fluids.
How often should you change transmission fluid in a 4L60E?
For optimum protection, change the Transmission Fluid and filter every 30,000 miles (unless you have a new vehicle that is filled with Dexron III ATF, which is supposed to be good for 100,000 miles).Can I mix DEXRON 3 and DEXRON 6?
DEXRON-VI can be used in any proportion in past model vehicles equipped with an automatic transmission, in place of DEXRON-III (for instance, topping off the fluid in the event of a repair or fluid change). DEXRON-VI is also compatible with any former version of DEXRON for use in automatic transmissions.
Can I use dexron IV instead of II?
ATF IV and Dexron II are different enough I’d suggest against using it, however all Dexron fluids are backwards compatible, so you could use Dexron III or Dexron VI. If you can get Dexron III you can mix it with the exiting Dexron II in your power steering reservoir without issue.
What kind of transmission fluid does a 5.3 Vortec take?
The type of transmission fluid used by the chevy silverado is carquest dexron®-vi full synthetic atf.
Can I use dexron 3 instead of ATF 4?
Fina’s product data sheet for its “Dexron-III/Mercon ATF” says it is recommended for “all late model GM…Chrysler and most imported car…automatic transmissions, as well as, (sic) those in Ford vehicles that call for a Mercon fluid.” But, again, a fluid compatible with Dexron III or Mercon is not going to be …How many miles is a 4L60E good for?
4l60e from 1996 held up well. Reverse kinda was finicky, every now and than it would slip but had a good life. I honestly think around 250-300k it should be rebuilt if its original.
Can I use ATF 3 instead of ATF 4?ATF+4 is backward compatible with ATF+3 so you can use it with no issues.
Article first time published onIs ATF +4 the same as dexron 3?
ATF+4 has specific additives designed for specific Chrysler transmissions. The additives and the make up of the fluid keeps the transmission working properly. If you put the wrong fluid in at best it won’t shift right, at worst it will ruin the transmission. Dexron is the same thing only for Chevy vehicles.
Can I add synthetic transmission fluid to regular?
Is it OK to mix synthetic ATF with a conventional and/or synthetic blend ATF? Yes. Synthetic ATF and conventional fluids are 100 percent compatible with each other.
Is dexron VI transmission fluid synthetic?
ACDelco DEXRON-VI Full Synthetic Automatic Transmission Fluid is the most recent release in the well-established DEXRON series of automotive transmission fluids. … ACDelco DEXRON-VI Full Synthetic Automatic Transmission Fluid helps automatic transmissions last longer and perform better.
Can you mix transmission fluid with power steering fluid?
Yes, you can. Just as you would for your car’s oil and antifreeze or brake fluid—as long as you’re mixing the same type of fluid with another of the same type (for example, ATF+ATF). Mixing different types of power steering fluid can cause you to lose your power steering.
What transmission fluid goes in a 4L60E?
ManufacturerTransmission TypeTransmission FluidCHEVROLET4L60EDEXRON IIIISUZU4L60EDEXRON IIIOLDSMOBILE4L60EDEXRON IIIPONTIAC4L60EDEXRON III
What transmission fluid does a 1995 Chevy Silverado take?
Notes:This specification has been updated from Dexron II or III to Dexron VI per a Technical Service Bulletin from the manufacturerCapacity:4 speed 4L60-E Total Fill 11.2 quarts 5 quarts Initial Fill
Can you add transmission fluid through dipstick?
Observe markings at end of dipstick. Your dipstick might have two markings for “full”—one warm, one cold. If the automatic transmission fluid level does not come up to the “warm” line, you’ll need to add automatic transmission fluid. Insert long funnel into automatic transmission fluid dipstick hole.
What kind of transmission fluid does a 4R70W take?
The 4R70W and many other Ford transmissions require MERCON V automatic transmission fluid.
Can you use dexron III in place of dexron II?
Dexron III supersedes Dexron II. Meaning, it replaced it. Anywhere Dex II is called for, Dex III can be used.
Can I use dexron VI instead of dexron II?
Valvoline DEXRON™-VI ATF is an automatic transmission fluid that can be used in new and old GM transmissions, is fully backward serviceable, and can be used wherever DEXRON™-II and/or DEXRON™-III are recommended.
Can a transmission last 300k miles?
Without service and maintenance, some transmissions can fail in as little as 100,000 miles. … With care and service, transmissions can last 300,000 miles or more. Scheduled fluid changes, transmission inspections, and band adjustments can save you thousands of dollars down the line from a premature transmission failure.
What is the life expectancy of a 5.3 Vortec?
The Vortec 5.3 is widely regarded as extremely reliable, with most engines having a lifespan within the 200k-300k mileage range. I own a 2002 Suburban with the LM7 engine in it and it’s running strong at 220k miles with virtually zero engine issues over my course of ownership.
How much is it to rebuild a 4L60E?
This item 4L60E Transmission Rebuild Kit Heavy Duty Master Kit with 3-4 Power-pack4L60E 4L65E 4L60-E Master Overhaul Rebuild Kit With All Alto HEG Heavy Duty FrictionsPrice$28500$255.00$255.00Sold ByWorld Wide Parts OutletWorld Wide Parts Outlet
Are transmission flushes worth it?
Many manufacturers recommend a transmission flush every 30,000 miles or 2 years. … A transmission flush can extend the life of your transmission. Like all preventative maintenance, the cost and time of this process can save you from expensive transmission repairs down the road.
Does General Motors recommend transmission flush?
Intervals vary based on the type of vehicle and transmission you have. For a manual transmission, it’s generally recommended that you change the fluid every 30,000 to 60,000 miles. For an automatic it could be anywhere from 30,000 to 100,000 miles.
How do you drain the transmission fluid on a 4l60e?
- Locate the upper transmission line on the passenger side and remove the line from your vehicle’s radiator. …
- Once the line is removed, connect your brass trans cooler line fitting. …
- Route the tubing to your catch pan or bucket. …
- Now you will begin to flush the fluid.
Can I use Mercon V instead of mercon?
Can I Use Mercon V Instead Of Mercon? According to the ford manual, Mercon V and Mercon aren’t compatible. However, car owners can use these dual usage fluids in transmissions that demand the MERCON V type fluid. Besides, some marks that these two fluids aren’t interchangeable.
Can I use Mercon V instead of Mercon LV?
It is the newest “low viscosity” synthetic formula. It is for all 2008 and newer Ford vehicles. Mercon V is not compatible with Mercon LV.
What's the difference between ATF and dexron?
DEXRON is the trade name for a group of technical specifications of automatic transmission fluid (ATF) created by General Motors (GM). … Originally the DEXRON name was associated exclusively with automatic transmission fluids, later GM released DEXRON gear oils and other lubricants under the DEXRON brand.
What is ATF plus type 7176?
Designed specifically for Chrysler designed transmissions using specification MS-9602 ATF, Pennzoil Platinum® ATF+4 also is backward compatible for service fill where Chrysler ATF+3®, ATF+2® or Type 7176 ATF is called for in all applications in transmissions, power steering systems and hydraulic systems.
What transmission fluid is compatible with ATF plus 4?
It is fully compatible with all transmissions that require Mopar ATF +®, Mopar ATF+2™ and Mopar ATF+3™. Valvoline ATF + 4 is for use in all applications specifying Mopar ATF+4 or Type MS-9602 fluid.
